Devil's Bush Backpacks: Storage & Painting Tips

By Victoria Miniatures by Victoria Lamb | Published: 2026-10-25

Category: Tips & Care

Learn how to assemble, store, and paint your Devil's Bush Backpacks x10. Get practical tips for 28mm wargaming gear and avoid common mistakes.

Quick Answer

Prepare your Devil's Bush Backpacks x10 with simple assembly, efficient storage, and a fast painting method that brings out the 3D-printed detail.

Why these backpacks need careful prep

The Devil's Bush Backpacks x10 are high-resolution 3D prints. They arrive clean but may have tiny support nubs or a slight texture from the printing process. A few minutes of prep prevents paint from pooling in unwanted spots and ensures a snug fit on your miniatures.

Painting order matters for 28mm scale

Painting the backpacks before gluing them onto a model lets you reach every strap and buckle. It also avoids accidentally brushing paint onto the miniature's uniform. If you prefer to attach them first, use a tacky glue so you can remove them later for touch-ups.

Step-by-Step Assembly, Storage, and Painting

Clean and trim each backpack: Inspect each 3D print for small support nubs or flash. Use a sharp hobby knife to slice them off flush. Sand any rough spots with fine-grit paper (600-800) so the surface is smooth. Skipping this step can leave visible bumps after priming.
Dry-fit before gluing: Test the backpack on your miniature's back or hip. Many 28mm figures have a natural curve; the flat back of the backpack may need a slight bend or a dab of putty to sit flush. Forcing a glued backpack can crack the print or leave a gap.
Prime in a neutral color: Spray or brush on a thin coat of gray, brown, or black primer. A light coat preserves the strap detail. Let it cure fully (at least 1 hour) before painting. Too much primer fills the fine grooves and makes the backpack look soft.
Basecoat and wash in one go: Apply a single coat of your chosen base color (olive drab, khaki, or leather brown). While it is still wet, dab a dark wash (thinned black or dark brown) into the recesses. This creates depth without a separate step. Work on one backpack at a time so the basecoat does not dry before the wash.
Highlight edges with a drybrush: After the wash dries, load a stiff brush with a lighter shade (e.g., khaki over olive) and wipe most of it off on a paper towel. Lightly drag the brush across raised edges and corners. Too much paint on the brush will flood the recesses and undo the wash effect.
Store extras in a labeled container: Keep unused backpacks in a small, compartmented box or a resealable bag. Add a silica gel packet to prevent moisture from warping the 3D-printed resin. Label the container with the set name for quick retrieval. Loose backpacks in a drawer get scratched or lost easily.

Product Facts

Devil's Bush Backpacks x10: 10x Bush Backpacks as seen in the Van Diemen's World Devils 10 Woman Squad. These are high res 3D prints. Compatible with Victoria Miniatures Guard and popular plastic kits. You can use these backpacks across multiple miniature ranges, not just the Devils squad, making them a versatile addition to your bits box.
Devil's Bush Backpacks x10