Victorian 10 Woman Firing Line Assembly & Painting Guide

By Victoria Miniatures by Victoria Lamb | Published: 2026-10-26

Category: How-to Guides

Learn how to assemble and paint the Victorian 10 Woman Firing Line from Victoria Miniatures. Step-by-step guide for 28mm wargaming miniatures.

Quick Answer

Assemble the Victorian 10 Woman Firing Line using the modular push-together system, then paint with a clean, historical style that works for Grimdark Empire or Victorian-era wargaming.

Understanding the Modular Kit

The Victorian 10 Woman Firing Line comes as a physical 3D printed modular kit on a high-density Snap Tray. Components are designed to be pushed together without glue, but a tiny drop of superglue on key joints adds durability for gaming.

Because the figures are modular, you can mix arms, torsos, and heads to create variety in poses. This is especially useful if you want to represent different firing positions or unit types.

Choosing a Painting Scheme

The Victorian women in this set fit both Grimdark Empire and historical Victorian-era armies. A simple three-color base coat with a wash works well for tabletop quality. For a more dramatic look, use dark blue or red coats with brass buttons.

The 28mm scale means you have room for detail on faces and equipment. A flesh tone wash followed by a sepia wash on the base gives a realistic aged effect.

Assembly and Painting Steps

1. Prepare Components: Remove each part from the Snap Tray and brush away any loose support material. The kit is designed for minimal cleanup, but check for tiny nubs on contact points. Do not force parts together until you have dry-fitted them first.
2. Test Assemble the Figure: Push the torso, arms, and head together without glue. Check that the firing pose aligns naturally. If a joint is too tight, gently sand the peg with fine-grit paper. A loose joint is better than a tight one—you can always add a tiny drop of glue.
3. Glue Key Joints: Apply a small amount of superglue to the peg of the arms and head, then press firmly into the torso. Hold for 10 seconds. Avoid gluing the legs if you plan to base them separately. Too much glue can seep out and ruin surface detail. Use a toothpick to apply just one drop.
4. Prime the Model: Use a spray primer in a neutral gray or black. Shake well and apply from 20 cm away in short bursts. Let dry for at least 30 minutes before handling. Priming in a well-ventilated area prevents dust from sticking to the wet surface.
5. Base Coat the Uniform: Paint the coat and trousers with a single opaque color. Two thin coats are better than one thick coat. Let each coat dry completely. Thin paint with a drop of water or medium to avoid obscuring the 3D printed texture.
6. Add Skin and Details: Paint faces and hands with a flesh tone. Use a fine brush for eyes (a tiny dot of white with a black pupil). Add brass or silver to buttons and belt buckles. If the eyes look messy, repaint the face and skip the eyes—most tabletop players won't notice.
7. Wash and Highlight: Apply a dark wash (e.g., Agrax Earthshade) to the recesses, then wipe the excess from raised areas. Let dry, then dry-brush a lighter shade on edges for definition. A wash darkens the model, so start with a slightly lighter base coat than your desired final color.

Product Facts

Victorian 10 Woman Firing Line: Fully modular, 'push-together', Grimdark troops. Physical 3D printed modular kit on a high density Snap Tray. You can test assemble each figure before gluing, making it easy to swap parts for unique poses or to fix mistakes.
Victorian 10 Woman Firing Line