Back to Blog
How-to Guides 2026-11-21 Victoria Miniatures by Victoria Lamb 0 views

Gun Carriage Assembly and Painting Tips

Gun Carriage Assembly and Painting Tips

Learn how to assemble and paint the Gun Carriage resin model for 28mm wargaming. Tips for fitting, preparation, and finishing your artillery piece.

What the Gun Carriage Kit Contains

The Gun Carriage is a heavy gun carriage designed for 28mm troops, hand cast in high-quality resin. It includes a split frame and front shield section, and is sculpted to fit the Standard and Heavy Artillery Wheels (sold separately). This guide covers assembly and painting steps based on the supplied information.

Key Product Facts

  • Gun Carriage: Heavy gun Carriage to suit 28mm troops. Confirms the scale compatibility for your 28mm wargaming armies.
    Gun Carriage
    Gun Carriage
  • Gun Carriage: Will fit the Standard and Heavy Artillery Wheels. Lets you choose the wheel type that best matches your artillery piece's look.
  • Gun Carriage: Includes split frame and front shield section. The split design allows easier assembly and painting access to the interior.
  • Gun Carriage: Hand cast in high quality resin. Resin requires different handling than metal or plastic; see preparation tips below.

Assembly Steps for the Gun Carriage

The kit contains a split frame and front shield section. The supplied information does not include detailed assembly instructions, so these steps are based on typical resin miniature assembly practices. Always test-fit parts before gluing.

  1. Prepare the resin parts: Wash the resin parts in warm soapy water to remove any mold release residue. Let them dry completely. Use a hobby knife and fine sandpaper to remove any mold lines or small flash.
  2. Test-fit the frame and shield: Dry-fit the split frame halves and the front shield section to check alignment. The split frame design may require slight adjustment to sit flush. If needed, sand the mating surfaces gently.
  3. Glue the frame and shield: Use a cyanoacrylate (super glue) or two-part epoxy designed for resin. Apply glue to one mating surface, press parts together, and hold for the time recommended in the product instructions. Allow the assembly to cure fully before handling.
  4. Fit the wheels: The carriage is designed for Standard or Heavy Artillery Wheels (sold separately). Test-fit the wheels on the axle points; if the fit is tight, gently sand the axle hole. Glue the wheels in place after painting if you prefer to paint the carriage and wheels separately.

Painting Tips for Resin Models

Resin models benefit from a primer coat to help paint adhere. Use a spray primer or brush-on primer formulated for resin. After priming, you can paint the carriage in your chosen scheme. The split frame design gives you access to interior areas that would be hard to reach on a one-piece model. Consider painting the interior before final assembly if you plan to detail the inside of the shield or frame. The supplied information does not specify paint types or drying times, so follow your paint manufacturer's recommendations. For a durable wargaming finish, seal the painted model with a matte or satin varnish.

Related Articles

Customer Service
Home
Products
Cart
Profile